Boot Modes

Boot Modes

PedalinoMini offers 8 different boot modes that determine available connections and functionality.

Available Boot Modes

Mode	Name	Description
1	Normal	BLE and WiFi enabled. Connects to WiFi (last AP → Provisioning → SmartConfig → WPS → Access Point) and awaits BLE-MIDI connections.
2	Bluetooth Only	Enables only BLE-MIDI connections. WiFi and Web UI disabled for lower power consumption.
3	WiFi Only	Enables WiFi connections (same connection sequence as Mode 1) but disables BLE for compatibility or power saving.
4	Access Point with BT	Creates a WiFi Access Point immediately without attempting to connect to previous networks. BLE-MIDI available.
5	Access Point without BT	Creates a WiFi Access Point immediately without BLE functionality.
6	Reset WiFi credentials	Clears saved WiFi settings to allow connection to a different network on next boot.
7	Ladder Config	Calibration mode for resistor ladder pedals (up to 6 buttons). Press and hold each footswitch until the timer completes. Footswitches are numbered by analog value (lower value = lower number).
8	Factory Default	Resets all settings to factory defaults.

If no buttons are pressed during startup, the device boots in the last used mode from options 1-5.
The default boot mode is Normal (1).

Selecting a Boot Mode

1. Press and release the EN button
2. Immediately press and hold the BOOT button
3. Follow the on-screen instructions:
4. Release the button when the desired mode appears

Feature Availability by Mode

Feature	Normal (Mode 1)	Bluetooth Only (Mode 2)	WiFi Only (Mode 3)	AP with BT (Mode 4)	AP without BT (Mode 5)
Connection Types
USB-MIDI	✅	✅	✅	✅	✅
Legacy MIDI	✅	✅	✅	✅	✅
BLE MIDI	✅	✅	❌	✅	❌
RTP-MIDI	✅	❌	✅	✅	✅
ipMIDI	✅	❌	✅	✅	✅
Interfaces
OSC	✅	❌	✅	✅	✅
Web UI	✅	❌	✅	✅	✅
Updates
OTA Firmware	✅	✅	✅	✅	✅
HTTP Firmware	✅	❌	✅	✅	✅

Notes:

• ✅ = Available
• ❌ = Not available
• USB-MIDI and DIN-MIDI are always available when hardware is properly connected